Browse Resources

This video, made available by the STEM Guitar Project, was recorded at the Guitar Build Institute held at Aptos Middle School in San Francisco, California in 2018. In the video Steve Brown demonstrates leveling the fretboard with the truss rod during electric guitar construction. The video runs 7:06...

This video is provided by Make Magazine and demonstrates how to make a catapult out of PVC piping. "This weekend, get some PVC and build a human powered catapult. Bre Pettis joins forces with Bill Gurstelle, seige weapon builder extraordinaire!" The video runs 3:05 minutes in length. 

This video, created by Make Magazine, is a presentation of how to make your own circuit board (PCBs) using a laserjet printer. Host Bre Pettis carefully details a step by step process to attain the desired output. Additional information about the project is found at www.makezine.com/podcasts. 

This page of semiconductor modules, from the University of Illinois at Urbana-Champaign's Department of Materials Science and Engineering, is split into several main topics: What are Semiconductors?, Historical Timeline, Future Trends, Scientific Principles, References, Resources, and Master...

This video, made available by the STEM Guitar Project, was recorded at the Guitar Build Institute held at Aptos Middle School in San Francisco, California in 2018. In the video Alex Moll demonstrates how to sand and drill fret dots during electric guitar construction. The video runs 5:12 minutes in...

This four-page guide from Edmonds Community College outlines a laboratory activity demonstrating the results of corrosion. Students observe the corrosion of nails, pennies, and aluminum foil in containers of fresh or salt water over a period of up to two weeks. The activity demonstrates differences...

This video, from Chippewa Valley Technical College, discusses robot simulation. "Running the simulator software, creating a virtual work cell, and adding a virtual robot to the work cell" is covered. RoboGuide is used during the video. This video runs 36:43 minutes in length. Additional modules are...

This video, from Chippewa Valley Technical College, goes over how to define and operate a robot in different joint coordinate modes. What the modes gets used for is emphasized. This video runs 17:58 minutes in length. A related PowerPoint slide deck and additional modules are available to view...

This video, from Chippewa Valley Technical College, demonstrates creating a material handling program. The video discusses specific program points and working with interference points. This video runs 15:02 minutes in length. A related video and more modules are available to view separately.

This video, from Chippewa Valley Technical College, covers refining and documenting a program. The video goes over "working with a program to refine moves, add comments/remarks, and optimize the program." This video runs 17:21 minutes in length. A related video and modules are available to view...