Browse Resources

Module Description: This learning module, from Support Center for Microsystems Education (SCME), serves as an introduction to statistical process control (SPC). "SPC is a set of tools used for continuous improvement and the assurance of quality in an active manufacturing process. This learning...

This 4-page lab activity, from the Nanotechnology Applications and Career Knowledge Resource Center (NACK Center), provides an overview and demonstration of the procedures necessary to perform contact lithography. Sections of the lab include Objective, Background, Experiment, and Questions. The...

Module Description: This module, from Support Center for Microsystems Education (SCME), provides an introduction to transducers including "what they are, how they work and how they are used in both macro and micro-size systems." This module is divided into the following four units: Pre-test...

​​​​​This collection of resources, from the Cybersecurity Education for Advanced Manufacturing Organizations project, is a part of the Intrusion Detection System/Intrusion Prevention System (IDS/IPS) Scenario. This scenario is a training module that focuses on using IDS/IPS to monitor and protect...

This 4-page lab guide, created by the Nanotechnology Applications and Career Knowledge Support (NACK) Center at Pennsylvania State University, is for a laboratory activity where students use an ion implanation simulation software to demonstrate the effects of ion implantation. Throughout the lab,...

Course Description: The Sensors Used in Connected and Automated Vehicles course was developed by Jackson State University and the Center for Advanced Automotive Technology (CAAT). This course introduces students to principles of sensors (GPS, MEMS, LIDAR, Radar, Ultrasonic, Infrared) used in...

Course Description:  The IT 312: Navigation Techniques Used in Connected and Automated Vehicles course was developed by Jackson State University and the Center for Advanced Automotive Technology (CAAT). This course introduces students to principles of navigation techniques used in connected and...

Course Description This sample module from ITSC 1325: PC Hardware, a course that educates learners on how to "install, configure, secure, and troubleshoot operating systems software and hardware to achieve high availability and performance," covers end user system security. Module 5 progresses...

This resource, published by Portland Community College, is the second issue of the third volume of J ATE. J ATE is a peer-reviewed technical journal focused on community college faculty and staff who work with technician education. This journal is cross-disciplinary and encompasses all technologies...

Course Description: The Joining Aluminum and Dissimilar Materials course was developed by Kettering University and the Center for Advanced Automotive Technology (CAAT). This course is intended to provide the fundamental knowledge and hands on experience on joining techniques related to aluminum...